QS138 70H mid-drive motor

What the QS138 70H is

The QS138 70H is a mid-drive electric motor from QSMOTOR, one of the most popular motor makers for electric dirt bike and light motorcycle builds. “138” refers to the motor family and “70H” to its 70mm magnet height. The current V3 version adds internal reduction gears, so the motor drives a standard chain sprocket at a lower speed and higher torque without a separate reduction stage. Fast E can supply the QS138 70H on its own or as part of a matched build with a controller and a custom Fast E battery, built to spec.

Key specifications

Spec QS138 70H V3 (as published)
Motor type Permanent magnet synchronous (PMSM), inner rotor
Magnet height 70mm, 5 pole pairs
Internal gear ratio 1:2.35
Rated power 3000W
Rated voltage 72V
Output 428 chain sprocket (14T or 15T depending on supplier)
Sensor Hall
Cooling and sealing Air cooled, IP67

Peak power and torque figures vary widely between listings. They depend on the controller, battery current and how the figures were measured.

Published figures for QS motors differ between QSMOTOR’s own pages and resellers, and between versions (for example V2 and the geared V3). We’ll confirm the exact version and specifications in your quote.

Who it suits

The 70H is the smaller, lighter QS138, and the common choice for lightweight electric dirt bike and pit bike builds, and conversions where space and weight matter more than outright power. Resellers describe it being used in Sur-Ron Light Bee-class bikes and in 72V light motorcycles. If you want more torque for a full-size frame or heavier rider, compare it with the bigger 90H. See QS138 70H vs 90H.

Controller pairing

A mid-drive motor is only as good as its controller setup. QSMOTOR’s own 70H V3 kit listing pairs the motor with a Fardriver ND72680 controller with Bluetooth, and Fardriver describes its ND72680 as matching well with QS motors. Other suppliers pair the 70H with VOTOL controllers. We match the controller to the motor, battery current and your goals, and set it up before the bike leaves the workshop. See Fardriver controllers and the Fardriver setup and app guide.

Battery

At 72V, the battery has to supply the current the controller asks for, through a BMS rated for it, in a pack that fits your frame. We spec custom Fast E batteries, built to suit your build. See conversion batteries.

Fitting

Mounting a mid-drive in a dirt bike frame takes brackets or a cradle, a correct chain line and secure, protected wiring. That’s the core of our e-moto conversions work, or see the complete QS138 conversion kit.

Frequently asked questions

Is the QS138 70H good for a dirt bike conversion?

It’s a common choice for lighter conversions at 72V. For heavier bikes and riders, consider the 90H.

What controller should I use with a QS138 70H?

Fardriver’s ND-series controllers are a common match, and QSMOTOR’s own kit uses an ND72680. We’ll match the controller to your battery and goals.

What is the difference between the V2 and V3 QS138?

The V3 has internal reduction gears (1:2.35), which changes output speed and torque at the sprocket. Confirm the version when ordering.

Can you supply the motor only?

Yes. We can supply the motor on its own or as part of a matched build.

Start a quote with the chat button, bottom-right. Prefer email or phone? Head to our contact page.

Shopping Cart