What this guide covers
You configure Fardriver controllers with an app or PC software. Searches for “Fardriver app”, “Fardriver settings explained”, “Fardriver wiring diagram” and “Fardriver app not sending code” show how many owners get stuck. In short, this guide explains the tools and the main settings in plain terms. Importantly, it’s not a tuning recipe. Be careful, because settings that are wrong for your motor and battery can damage the controller, motor or battery, or make the bike unsafe. So if in doubt, ask someone experienced to set it up.
The tools
- iPhone app: Fardriver’s app on the Apple App Store (called Nanjing Fardriver, 南京远驱) connects over Bluetooth to monitor the controller’s voltage, current and working state, set parameters, draw working curves and upgrade the controller’s software.
- Android app: available as a signed APK from Fardriver’s official download page. However, only install it from the official source.
- PC software: Fardriver’s download page lists Windows software for configuring controllers via a CAN interface, and says there’s currently no Mac version.
- Bluetooth adaptor: Fardriver supplies controllers with a Bluetooth adaptor or programming cable. The app talks to the controller through it.
Fardriver also publishes a controller manual covering wiring, and an app manual, on the same download page.
Self-learning
Fardriver controllers have a self-learning function that detects the motor’s Hall sensors and phase arrangement, so the controller drives the motor correctly. Normally, you do it once at setup, and then again after changing the motor or phase wiring. Also, follow the manual’s procedure exactly, with the wheel clear of the ground and the bike secured. For example, a failed or skipped self-learn is a common cause of a motor that stutters, runs backwards or won’t run smoothly.
The main settings, explained
- Battery voltage and protection limits: must match your pack. Also, don’t set them beyond the ratings of the battery and its BMS.
- Bus (battery) current and phase current: set how hard the controller pulls from the battery and pushes into the motor. Fardriver lets you set both. However, they must stay within the battery’s, BMS’s and motor’s ratings.
- Speed modes and maximum speed: separate limits for forward, reverse and economy modes.
- Throttle response: the throttle threshold and curve, which sets how sensitive the bike feels.
- Regen: regenerative braking strength, where supported.
- Flux weakening: extends top speed at the cost of efficiency and heat. For that reason, we set it to suit your motor.
Settings to leave alone
First, don’t raise current limits above the ratings of your battery, BMS and wiring. Second, don’t disable temperature or voltage protection. Finally, don’t copy someone else’s settings file from a forum, because their motor, battery and controller version won’t match yours.
Troubleshooting connection problems
If the app won’t connect, check that the controller is powered, the Bluetooth adaptor is plugged in and the phone’s Bluetooth and location permissions are on. Also, make sure you’re using the official app. If it still won’t connect, or settings won’t save, contact us or the seller you bought from.
In addition, we set up Fardriver controllers we supply, and can review settings on existing builds. See Fardriver controllers, controller repair and diagnosis and QS138 conversion kit.
Frequently asked questions
Where do I download the Fardriver app?
From the Apple App Store for iPhone, and from Fardriver’s official download page for Android.
Is there a Fardriver app for Mac?
Fardriver says its PC software is currently Windows only.
Why does my motor stutter after fitting a Fardriver?
A failed self-learn or wrong Hall or phase setup is a common cause. Stop and have it checked.
Can you tune my Fardriver remotely?
Ask us. We usually prefer to review settings with the bike in the workshop.
Start a quote with the chat button, bottom-right. Prefer email or phone? Head to our contact page.
